Stainless General Purpose High Pressure Solenoid Valve – Normally Open (IGM YBA)

Stainless General Purpose High Pressure Solenoid Valves operate with AC and DC electrical energy and provide control of various fluids (air, gas, fuel, steam, water, etc.) and are two or three-way valves. They consist of a body, sleeve, coil, diaphragm and core. Solenoid valves are normally closed (the coil opens the closed valve when it receives energy) and
It is manufactured in two types: normally open (to close the valve that is open when it receives energy from the coil) and normally open (to close the valve that is open when it receives energy from the coil).

SOLENOİD VALF SEÇİMİNDE DİKKAT EDİLMESİ GEREKENLER:

-The coil should be selected according to the operating voltage it will be used in (AC-DC). Protection and insulation should be provided according to the place where it will be applied. (It opens when the electricity comes, and when you cut the electricity, it returns to the closed position)
-Minimum and maximum pressure values in the line or system you will use are very important in selecting the valve.
-The nature and temperature of the fluid are direct factors in the selection of the valve.

-Pay attention should be paid to the installation so that the direction of the fluid and the arrow mark on the body are in the same direction.
-Since the solenoid valve does not function as a check valve, the fluid flows back under reverse pressures. In these cases, it is correct to install a check valve after the solenoid valve in terms of connection.
-The line where the valve is installed must be cleared of dirt.